4News -> FAQ
Your position: Home page ->  News ->  FAQ
2021
-
11
-
30
1. Rotor structure and type: The geometry and size of the rotor working surface largely determine the production capacity and mixing quality of the internal mixer. There are two basic configurations of internal mixer rotors: shearing rotors and meshing rotors.
2021
-
11
-
30
If the internal mixer leaks, you should first check whether the raw material contains a lot of water. If not, you should see whether the rubber port of the car is complete, and then try the rotor, mixing chamber, discharge door, and pressure hammer to check the location of the leak.
2021
-
11
-
30
As one of the parts of the continuous mixer, the roller is subjected to greater transverse pressure, friction, temperature stress, large and small drive gears and speed ratio gears when working. The temperature caused by the temperature difference between the inside and outside of the roller
2021
-
11
-
30
1: The contact surface between the fixed ring and the moving ring of the internal mixer is uneven, and a sealing oil film cannot be formed. Treatment method: disassemble the internal mixer and check the fixed circle. If the contact surface is not strained, and the contact rate is low, running-in processing is required. The running-in time is 4-8h or more, and the contact surface cannot be cut off during running-in.
2021
-
11
-
30
How to maintain the rubber mixer during use: 1. Fill the square bearing with butter for lubrication (twist the oil cup 2) every day when starting up, add a small amount of material to preheat for 5 minutes before adding material for mixing, at any time during the operation of the machine Add to prevent working in the state of oil cut.
   Total6  Total Pages2 | Page1  9First Page   7Previous   Next8   Last Page:  Jump
QQ

Phone

App

the public

Applets

E-mail